CLONE installation The CLONE system is built and installed by the command: @CLONEBLD ALL This command file will assemble all modules and build the three tasks which comprise the CLONE system. These tasks are: 1. CLONE the command language processor/interpreter itself 2. ...CL1 the MCR interface command. This task is installed from file CL1.TSK 3. CL1... the terminal input task. This task is installed from file CL1IN.TSK CL1... normally installs in partition VALPAR. If this partition has not been created or is not large enough the task may be installed in GEN. However as it is not checkpointable during input it is preferable to run CL1... in its own partition or FIX it. The size of this task is 2100(8) bytes. When CLONE has build successfully issue the command: CL1 @CLONETEST