[352,4]README.1ST - FILES SUBMITTED BY: Mark Ransom Datamap, Inc. 6874 Washington Av. S. Eden Prairie, MN 55344 This UIC contains files for the TALK program, version V07.00. This version was modified from version 06.00, from [352,2] on the Fall '82 tape. TALK is a terminal emulation program which enables a user on an RSX-11M V3.2 or V4.0 system with the full duplex terminal driver to communicate with a remote host computer over a single line interface (such as a DLV11 or DL11). This version also allows the use of any terminal interface (such as a DZ11) when the line is set to 300 baud. The program begins in terminal mode, and has the capability of bi-directional file transfers. See the documentation and program source for details. NOTES.DOC also contains instructions for building TALK. The latest version includes some optimizations in the local terminal output, but the main addition was the binary transfer mode for RSX-11M systems. A companion program, MOV, is used in the remote system to convert and transfer a file block by block, resulting in an identical copy. The binary transfer mode is selected as an assembly option in TALKSYS.MAC. The MOV program must be copied to the remote system (perhaps using a non-binary version of TALK), assembled, and installed as the MOV command. The very extensive documentation file, TALK.DOC, has not been updated to reflect the latest changes. Kindly send notice of any changes you make to the program to: Bob Turkelson NASA/Goddard Space Flight Center Code 935 Greenbelt, MD 20771 (301) 344-5003 NOTES.DOC TALK instructions and notes TALKSYS.MAC TALK prefix file for local and host system parameters. *.MAC TALK source files. TALK.CMD Command file to assemble and build TALK. TALK.DOC TALK documentation. (Still the same - not updated.) TALK.RNO Runoff input file for TALK documentation. MOV.MAC Source for binary file transfer helper for remote system. MOV.BLD Taskbuild command file for MOV. [352,4]README.1ST - END