hisaxctrl - configure HiSax-Module


SYNOPSIS

       hisaxctrl DriverId command parameters


DESCRIPTION

       hisaxctrl  is  used to setup the HiSax-ISDN device driver.
       All logging-output is sent to the device /dev/isdnctrl. So
       you can show it by executing cat /dev/isdnctrl.

       The  use  of  hisaxctrl  makes sense, if you are using the
       HiSax driver only.


OPTIONS

       DriverId
              is used to identify the card when using  more  than
              one  passive  card.  While loading the hisax module
              with insmod, or modprobe the  DriverId  is  set  by
              appending  id=idstring1%idstring2%...   to the com­
              mandline.

       command
              is an integer selecting  the  setup  category.  The
              following  values  are defined for setting the log­
              ging-level of the HiSax-ISDN device driver:

               0 reports card status infos.
               1 selects generic debugging.
              11 selects layer 1 developement debugging.
              13 selects layer 3 developement debugging.

       the following commands are used to enable special features
       during runtime of the HiSax-ISDN device driver.

               2 set B-channel ON delay to parameter (in ms)
               5 set B-channel in leased mode
               6 set B-channel in TESTLOOP mode
               7 set/reset card in Point To Point mode
               8 set card in FIXED TEI mode
               9 load firmware for DSP cards
              10 set B-channel usage limit to 1 or 2 channels
              12 set echo logging mode (only for some cards)
                 B-channel usage limit needs to be 1 if enabled

       parameter
              For  debug settings this is an integer representing
              a bitmask. Every bit in this mask switches a  debug
              facility on or off. Depending on the selected cate­
              gory, the following values are defined:

              With generic debugging selected:

              0x002 Top state machine
              0x004 D-Channel Q.931 (call control messages)
              0x008 D-Channel Q.921
              0x010 B-Channel X.75
              0x020 D-Channel l2
              0x040 B-Channel l2
              0x080 D-Channel link state debugging
              0x100 B-Channel link state debugging
              0x200 TEI debug
              0x400 LOCK debug in callc.c
              0x800 More debug in callc.c (not for normal use)

              With layer 1 developement debugging selected:

              0x001 Warnings (default: on)
              0x002 IRQ status
              0x004 ISAC
              0x008 ISAC FIFO
              0x010 HSCX
              0x020 HSCX FIFO (attention: full B-Channel output!)
              0x040 D-Channel LAPD frame types

              With layer 3 developement debugging selected:

              0x001 Warnings (default: on)
              0x002 l3 protocol discriptor errors
              0x004 l3 state machine
              0x008 charge info debugging (1TR6)


EXAMPLE

       hisaxctrl HiSax 1 0x3ff
              enables full generic debugging.


AUTHOR

       © 2000  by Karsten Keil <kkeil@suse.de>


SEE ALSO

       isdnctrl(8), isdn_cause(7), isdninfo(4).


Man(1) output converted with man2html