[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [compost_tea] CFM required and pumps
Yeah Peter, . They are good for painting. That 90 cfm would run a 22,000 g CT brewwer until the pump quit which would be after a couple days. constant running.
J Peter Young <peter@bennettvalleyvineyards.com> wrote:
I've been looking for something that will generage 8+ CFM and they aren't easy to find. Anyone have any suggestions? I see there are High Volume Low Pressure painting systems that put out 90+ CFM. Anyone have any experience with these?
Peter
In a message dated 5/5/2003 4:01:46 PM Eastern Daylight Time, peter@bennettvalleyvineyards.com writes:
I'm setting up a 250 gallon plastic fertilizer container for compost tea. Can anyone tell me how many cfm I need? Looking to keep the DO as high as possible. I have a whitewater LT26 that puts out 4.2 CFM, but when I hooked this up to a soaker hose, I didn't get as much action as I was expecting.
Peter
Peter, I was told by P. Wagner of SFI NY as a minimum 1L/Minute per gallon which comes to .035 cfm per gall
on. For 250 gallons that says 8.8 CFM so according to that you are about half required.
Maybe the commercial brewers would like to comment on the above numbers and say if they agree/disagree. They seem reasonable to me from what I know.
Dan Lynch
Long Mountain Vineyard
To unsubscribe from this group, send an email to:
compost_tea-unsubscribe@yahoogroups.com
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
To unsubscribe from this group, send an email to:
compost_tea-unsubscribe@yahoogroups.com
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
Yahoo! Groups Sponsor |
![]() |
![]() |
To unsubscribe from this group, send an email to:
compost_tea-unsubscribe@yahoogroups.com
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.